DVP XC 405 Vacuum System

Product details

Overview

The DVP XC 405 is a vacuum system. The documented capacity is 410 / 490 m³/h (50 / 60 Hz). Total final pressure is 0.1 mbar (gas ballast closed). Ask Girovac to match the configuration to your duty and electrical supply.

Choosing the right configuration

For a packaged or central vacuum installation, list each user, its operating pressure and which users run together. Agree the receiver, controls, filtration and standby requirement as part of the quotation. Allow for distribution losses when specifying the flow and pressure required at each outlet.

A combined lubricated pumping package. Its continuous-duty limit is 0.5 mbar, which is different from the 0.1 mbar final-pressure figure. Size the installation around the sustained duty.

Technical specifications

Values apply to the stated model and conditions. Where two figures are shown, follow the 50 / 60 Hz order in the label. Confirm the motor, connections and supplied accessories in your quotation.

Manufacturer documentation

Download the original DVP XC 405 datasheet (PDF). The original document includes its revision information and any additional model-specific conditions.

Frequently asked questions

Which related DVP models should I compare?

Compare DVP XC 605, DVP XC 905, DVP CPAP Duplex. Check the working pressure, capacity and motor rather than choosing by the model number alone. Browse the full DVP range.

Which gauge should I use with this pump or system?

For suitable rough-vacuum duties, compare industrial vacuum dial gauges. Where a display, output or control signal is needed, review digital vacuum meters and vacuum transducers. Measure at the chamber or point of use when that is the pressure your process depends on. Gauge calibration can be specified around the operating range and required test points.

How do I select oil and service parts?

Use the complete model, serial number and manufacturer oil specification. This datasheet specifies DVP BV100 (SW100). Different suffixes and gear compartments can require different lubricants. See vacuum oils and greases and send the nameplate details when requesting parts.

What information does Girovac need for a quotation?

Send the model, required flow at working pressure, gas or vapour, operating hours, electrical supply and any installation restrictions. For a replacement, include a nameplate photograph. We will confirm the proposed configuration, price and lead time before ordering.

Discuss your application

Call 01692 660 117 or use the product enquiry form. Give us the model and working conditions so we can check the equipment and supporting accessories together.